Hyundai Equus Manuals

Hyundai Azera: Hood Latch Release Handle Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Hood Latch Release Handle Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
   
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Installation is the reverse of removal.
   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
Hood Latch Release Handle Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch Components and Components Location
Component Location 1. Hood latch ...

See also:

Components and Components Location
Components Location [Vehicle Components] 1. Automatic transaxle2. Transaxle Control Module (TCM)3. Shift lever4. Date Linke Connector (DLC) [Transaxle Components] 1. Input speed sensor2. O ...

Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Disconnect the LDWS unit connector (A). 4. Remove the LDWS unit after disengaging the mou ...

Rear Door Outside Handle Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the hole plug (B). 3. After loosening the mounting bolt, then remove the rear door outside hand ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com