Hyundai Equus Manuals

Hyundai Azera: Hood Latch Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Hood Latch Repair procedures

Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Detach the clips, then remove hood latch cover (A).

3.
Remove the hood latch (A) mounting bolts.

Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Disconnect the hood latch cable (A) and remove the hood latch (B).

5.
Installation is the reverse of removal.
   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
Hood Latch Components and Components Location
Component Location 1. Hood latch ...

Trunk Lid
...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Specifications Direct control VFS[OD/C] ? Control type : Normal low type Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...

Specifications
Specification ItemBulb Watt(W)TypeFrontHead lamp(High)55H7Head lamp(Low)55(General) /35(HID)H7/D1SPosition lampLEDLEDTurn signal lamp21HY21WFog lamp35H8Side markerLEDLEDRearStop lamp / Tail lampL ...

Repair procedures
Replacement     • Be careful not to damage the fender and body. • When removing the clips, use a clip remover. 1. Remove the head lamps. (Refer to Body Elect ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com