Hyundai Azera: Input Speed Sensor Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Specifications
| Specifications |
? Type: Hall effect sensor
| Operation condition [°C(°F)] | (-40~150) -40~302 | |
| Air gap(mm)in. | (0.95~1.65)0.037~0.065 | |
| Output voltage(V) | High | 1.18~1.68 |
| Low | 0.59~0.84 | |
Input Speed Sensor Description and Operation
Description
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transaxle and delivers the
readings to the Transaxle Control Module(TCM). The sen ...
Input Speed Sensor Schematic Diagrams
Circuit Diagram
...
See also:
Input Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...
Rear Oil Seal Repair procedures
Removal
1.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).
Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil s ...
Fuel Filler Door Release Actuator Repair procedures
Inspection
1.
Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts.
2.
Remove the luggage side trim [LH].
(Refer to Body - "Trunk ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com