Hyundai Equus Manuals

Hyundai Azera: Input Speed Sensor Description and Operation - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Input Speed Sensor Description and Operation

Description
Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Transaxle Oil Temperature Sensor Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Input Speed Sensor Specifications
Specifications ? Type: Hall effect sensor Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84 ...

See also:

Brake Booster Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depress ...

Rear Upper Arm Repair procedures
Removal 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when ...

Seat Heater Switch Repair procedures
Inspection Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the sea ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com