Hyundai Azera: Transaxle Oil Temperature Sensor Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Remove the battery and the battery tray.
|
| 2. |
Remove the under cover (A).
|
| 3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
| 4. |
Remove the valve body cover (B) and eyebolt (A).
|
| 5. |
Disconnect the oil temperature sensor connector (A).
|
| 6. |
Remove the oil temperature sensor (A) after removing a bolt.
|
| Installation |
| 1. |
Installation is the reverse of removal. |
After replacement or reinstallation procedure of the oil temperature sensor, must perform procedures below.
|
Transaxle Oil Temperature Sensor Schematic Diagrams
Input Speed Sensor Description and OperationAmbient Sensor Description and Operation
Description
1.
The ambient temperature sensor is located at the front of the
condenser and detects ambient air temperature. It is a negative type
thermistor resistance will increase with lower ...
Using AUX Mode
Press the key
Select [AUX]
An external device can be connected to play music.
✽ NOTICE
If an external device connector is connected with the AUX terminal, then
AUX mode will ...
Spark Plug Components and Components Location
Components
1. Spark plug
...