Hyundai Azera: Heater
- Components and Components Location
- Heater Unit Repair procedures
- Heater Core Repair procedures
- Evaporator Core Repair procedures
- Temperature Control Actuator Components and Components Location
- Temperature Control Actuator Description and Operation
- Temperature Control Actuator Repair procedures
- Mode Control Actuator Components and Components Location
- Mode Control Actuator Description and Operation
- Mode Control Actuator Repair procedures
Cluster ionizer Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to D ...
Components and Components Location
Component Location
Components
1. Heater Case (LH)2. Heater Case (RH)3. Separator4. Heater Case (Lower)5. Drain Hose6. Insulation7.Shower Duct (RH)8. Temp Actuator(PA)9. Temp Door Cam10. Evapora ...
See also:
Exhaust Manifold Repair procedures
Removal and Installation
[LH]
1.
Disconnect the LH front and rear heated oxygen sensor (HO2S) connector.
(Refer to Fuel System - "Heated Oxygen Sensor (HO2S)")
2.
Remove the front muffler ...
Output Speed Sensor Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON'T remove the camshaft posit ...
Categories
Hyundai Azera Manuals
2011-2026 Copyright www.hgmanual.com