Description |
1. |
Heater unit includes mode control actuator and temperature control actuator. |
2. |
Temperature control actuator is located at the heater unit.
It regulates the temperature by the procedure as follows. Signal from
control unit adjusts position of temperature door by operating
temperature switch and then temperature will be regulated by the
hot/cold air ratio decided by position of temperature door |
Fuel Sensor Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the fuel sender connector (A).
3.
Remove the fuel sender (A) after releasing the fix hook.
I ...
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ventilation hose (A) from the fuel tank air filter.
3.
Disconnect the vapor tube q ...
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...