Hyundai Azera: Basic Service Symbols

General Information

Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T ...

General Information

Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. SymbolMeaningDo not reuse the p ...

See also:

Repair procedures
Replacement [Removal]     • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. (Refer to ...

Input Speed Sensor Specifications
Specifications ? Type: Hall effect sensor Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84 ...

Buzzer Repair procedures
Removal Buzzer 1. Disconnect the negative(-) battery terminal. 2. Remove the front left wheel guard. 3. Remove the external buzzer (A) after disconnecting the connector. Installation ...