Hyundai Azera: Body Side Molding

Rear Door Side Weatherstrip Repair procedures

Replacement 1. Detach the clips, then remove the rear door side weatherstrip (A). 2. Installation is the reverse of removal.     • Replace any damaged clips. ...

Roof Side Molding Repair procedures

Replacement [General Type]     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent da ...

See also:

Panoramaroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the panoramaroof motor (A) connector. 4. Gro ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn si ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to ...