Hyundai Azera: Roof Side Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
| Replacement |
[General Type]
|
| 1. |
Using a screwdriver or remover, remove the roof side molding (A).
|
| 2. |
Installation is the reverse of removal.
|
[Panoramaroof Type]
|
| 1. |
Using a screwdriver or remover, remove the roof molding (A).
|
| 2. |
Installation is the reverse of removal.
|
Fender Garnish Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
See also:
Symbols used in this manual
Warnings, cautions and Notices
WARNING
A WARNING indicates a situation in which harm, serious bodily injury or death
could result if the warning is ignored.
CAUTION
A CAUTION indicates a situatio ...
SS-A Solenoid Valve(ON/OFF) Specifications
Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
? Control type : Normal low type
Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11
...
Intake Actuator Repair procedures
Inspection
1.
Ignition "OFF".
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grou ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com