Hyundai Azera: Fender Garnish Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Fender Garnish Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Fender Garnish Repair procedures
| Replacement |
|
| 1. |
After loosening the mounting screws, then remove the fender garnish (A).
|
| 2. |
Installation is the reverse of removal.
|
Roof Side Molding Repair procedures
Replacement
[General Type]
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent da ...
Front Wheel Guard Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
See also:
Blower Unit Components and Components Location
Component Location
Components
1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...
Parking Brake Cable Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the parking bra ...
Front Seat Belt Buckle Components and Components Location
Component Location
1. Front seat belt buckle
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com