Hyundai Azera: Waist Line Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Waist Line Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Waist Line Molding Repair procedures
| Replacement |
|
| 1. |
Using a screwdriver or remover, remove the front waist line molding (A). |
| 2. |
Using a screwdriver or remover, remove the rear waist line molding (B). |
| 3. |
Installation is the reverse of removal.
|
Rear Mud Guard Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
Side Sill Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
See also:
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...
Closing the trunk
To close, lower the trunk lid, then press down on it until it locks. To be sure
the trunk lid is securely fastened, always check by trying to pull it up again.
Once the trunk is opened and then clos ...
Alternator Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover.
3.
Disconnect the alternator connector (A) and the cable (B) from the 'B' terminal.
4 ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com