Inspection |
1. |
Remove the fuse box cover. |
2. |
Remove the starter relay (A). |
3. |
Using an ohmmeter, check that there is continuity between each terminal.
|
4. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87. |
5. |
If there is no continuity, replace the starter relay. |
6. |
Install the starter relay. |
7. |
Install the fuse box cover. |
Cargo weight
This figure includes all weight added to the Base Curb Weight, including cargo
and optional equipment. ...
Rear Back Armrest Cup Holder Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
IMS Power Seat Control Schematic Diagrams
Circuit diagram
...