Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
After loosening the mounting screws, then remove the rear door inside handle (A). |
3. |
Installation is the reverse of removal.
|
Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light ...
Engine Hanger Repair procedures
Removal and Installation
[Front engine hanger]
1.
Remove the front engine hanger (A)
Tightening torque:
44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
2.
Install in the reverse ord ...
Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you
drive and when you drive.
Each of these factors affects how many miles you can get from a gallon of fuel.
To opera ...