Hyundai Azera: Cooling System
- Coolant Repair procedures
- Heater Hose Components and Components Location
- Heater Hose Repair procedures
- Radiator Hose Components and Components Location
- Radiator Hose Repair procedures
- Cooling Fan Components and Components Location
- Cooling Fan Repair procedures
- Radiator Components and Components Location
- Radiator Repair procedures
- Reservoir Tank Components and Components Location
- Reservoir Tank Repair procedures
- Water Temperature Control Assembly Components and Components Location
- Water Temperature Control Assembly Repair procedures
- Water Pipe Components and Components Location
- Water Pipe Repair procedures
- Water pump Components and Components Location
- Water pump Repair procedures
- Water pump Troubleshooting
- Thermostat Components and Components Location
- Thermostat Repair procedures
- Thermostat Troubleshooting
Cylinder Block Repair procedures
Disassembly
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion. ...
Coolant Repair procedures
Replacement And Air Bleeding
Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure escaping from
the radi ...
See also:
Photo Sensor Repair procedures
Inspection
1.
Ignition "ON"
2.
Using the scan tool.
3.
Emit intensive light toward photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...
Starter Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
3.
Remove the starter cover (A).
Tightening torque :
Bolts: 8.8 ~ 13.7 N. ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com