Hyundai Equus Manuals

Hyundai Azera: Cooling Fan Repair procedures - Cooling System - Engine Mechanical System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Cooling Fan Repair procedures

Removal and Installation
1.
Remove the battery and tray.
2.
Remove the air duct and air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
3.
Loosen the upper hose fixing bolt (A), and disconnect the fan motor connector (B)

   
The radiator hoses are still connected.
4.
Remove cooling fan assembly (A).

Tightening torque :
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)

5.
Installation is reverse order of removal
Cooling Fan Components and Components Location
Components 1. Cooling fan2. Fan motor3. Fan shroud ...

Radiator Components and Components Location
Components 1. Radiator2. Radiator mounting bracket3. Radiator cap4. Drain plug5. Mounting insulator ...

See also:

ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

Canister Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ventilation hose (A) from the fuel tank air filter. 3. Disconnect the vapor tube q ...

Power Seat Control Switch Repair procedures
Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Lumb ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com