With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
A : Lumbar support switch



|
In case of IMS switch inspection, refer to "IMS" system. |


| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the seat side cover (A).

|
| 3. |
Disconnect the lumbar switch connector (A). 
|
Power seat control switch
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the door trim (A) after loosening mounting screws.

|
| 3. |
Remove the memory power seat control switch (A) after loosening connector and screws (3EA) from the door trim. 

|
| - |
Make sure that the lumbar control switch connectors and related connectors are plugged in properly. |
| - |
Check the lumbar control switch operates normally. |
|
| 1. |
Connect the connectors and reassemble the lumbar control switch. |
| 2. |
Reassemble the seat side cover. |
Power seat control switch
| - |
Make sure that the IMS control switch connectors and related connectors are plugged in properly. |
| - |
Check the IMS control switch operates normally. |
|
| 1. |
Install the memory power seat control switch after connecting the switch connector. |
| 2. |
Install the driver door trim. |
| 3. |
Install the negative (-) battery terminal. |
See also:
Cluster ionizer Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to D ...
Front Door Latch Repair procedures
Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Disconnect the connector (A) and front door latch wiring harness.
3.
Remove the front door latc ...
Troubleshooting
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor. ...