Hyundai Azera: Passenger Airbag (PAB) Module Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Description and Operation
| Description |
Passenger Airbag (PAB) module is located in the passenger
crash pad. This PAB contains 2 firing squibs of airbag and 1 firing
squib of active vent. Depending of crash speed or the tightening of seat
belt, it is decided a timing about both 2 firing squibs of airbag and 1
firing squib of active vent. At the moment of vehicles collisions, the
firing squib of active vent make airbag distended and then consecutively
leaked gases of airbag through a hole at once. These operations reduce
an injury of the passenger's head. At first, the active vent sets a
rapid deployment of airbag by keeping the pressure, after deployment of
airbag it emits the gases of upper airbag. The Working Principle of
Tether Cutter: When receive an electrical signal, Tether Cutter cuts a
strap which is been attached Active vent in order to open a hole of
upper airbag.
The working range of Active Vent
| 1. |
If occupant in passenger seat is not belted, active vent is disposed in the end of crash event regardless of crash severity. |
| 2. |
If occupant is belted and crash severe enough to require 2 stage passenger airbag deployment is occurred, active vent is activated to optimize occupant protection. |
| 3. |
Low-Speed + Belted : Inflator of Primary Fire + 2 Stage & Active Vent disposal in the end of crash event. |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the driver airbag module mounting bolts (A).
3.
Remove the wiring fix ...
See also:
Don't let ice and snow accumulate underneath
Under some conditions, snow and ice can build up under the fenders and interfere
with the steering. When driving in severe winter conditions where this may happen,
you should periodically check unde ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, hom ...
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle or battery, follow the jump starting procedures.
If in doubt, we strongly recommend ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com