Hyundai Equus Manuals

Hyundai Azera: ETC (Electronic Throttle Control) System Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: ETC (Electronic Throttle Control) System Repair procedures

Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
C.T
0.5
4.5
W.O.T
4.41
0.59

ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the air intake hose.
3.
Disconnect the ETC module connector (A).
4.
Disconnect the coolant hoses (B).
5.
Remove the installation bolts, and then remove the ETC module (C) from the engine.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.

Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at th IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
   
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram ...

Barometric Pressure Sensor (BPS) Description and Operation
Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assemby. It senses absolute pressure of the air cleaner assemby and transfers the ...

See also:

Seat Belt Buckle Switch (BS) Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status inp ...

Hood Latch Release Handle Components and Components Location
Component Location 1. Hood latch release handle ...

Front Body Body Repair
Front Body A Hood hinge mounting hole (O10)Fender panel mounting hole (O9)Front shock absorber mounting hole (O11)Cowl top cover mounting hole (O9)Roof panel front cornerFront pillar outer corne ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com