Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the ventilation hose (A) from the fuel tank air filter. |
3. |
Disconnect the vapor tube quick-connector (B) and the quick-connector (C). |
4. |
Remove installation bolts (A) and then remove the canister assembly. |
5. |
Remove the bracket (A) from the canister after removing a bolts (B). |
Inspection |
1. |
Check for the following items visually.
A: Canister - Atmosphere
B: Canister - Fuel Tank
C: Canister - Intake Manifold
|
Installation |
1. |
Installation is reverse of removal. |
Canister installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lb-ft) |
Rear Wheel Speed Sensor Repair procedures
Removal
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightenin ...
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
engi ...
Audio system
✽ NOTICE
If you install an aftermarket HID head lamp, your vehicle’s audio and
electronic device may malfunction.
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleane ...