Hyundai Azera: Water Temperature Control Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures
| Removal and Installation |
| 1. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose") |
| 2. |
Disconnect the throttle body water hoses.
|
| 3. |
Disconnect the heater hoses.
(Refer to Cooling System - "Heater Hose") |
| 4. |
Disconnect the WTS & gauge unit connector (A)
|
| 5. |
Separate the engine wiring protector mounted on the water temperature control assembly.
|
| 6. |
Remove the water temperature control assembly (A) and the gaskets.
|
| 7. |
Install in the reverse order of removal. |
Water Temperature Control Assembly Components and Components Location
Components
1. Water temperature control assembly2. Throttle body water hose3. Gasket
...
Water Pipe Components and Components Location
Components
1. Water center pipe2. O-ring
...
See also:
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system service.
Observe the instructions described in this manual, or the airbags c ...
Closing the trunk
To close, lower the trunk lid, then press down on it until it locks. To be sure
the trunk lid is securely fastened, always check by trying to pull it up again.
Once the trunk is opened and then clos ...
Variable Intake Solenoid (VIS) Valve Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between the VIS valve terminals 1 and 2.
4.
Check that the resistance is within ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com