Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration, or damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary.
Rear Oil Seal Repair procedures
Removal
1.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).
Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil s ...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts. The purpose of the pretensioner is to make sure that the seat belts fit tightly
against the occupan ...
Front Driveshaft Components and Components Location
Component Location
1. Driveshaft(LH)2. Inner shaft bearing bracket assembly3. Driveshaft(RH)
Components
1. BJ Assembly2. Clip3. BJ Boot Band4. BJ Boot5. Dynamic Damper Band6. Dynamic Damp ...