Hyundai Equus Manuals

Hyundai Azera: Water Pipe Repair procedures - Cooling System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Water Pipe Repair procedures

Removal and Installation
1.
Remove the delivery pipe and injector assembly.
2.
Remove the water temperature control assembly.
(Refer to Cooling System - "Water Temperature Control Assembly")
3.
Remove the water center pipe (A).

Tightening torque:
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

   
Do not reuse water pipe O-ring.
4.
Installation is in the reverse order of removal.
Water Pipe Components and Components Location
Components 1. Water center pipe2. O-ring ...

Water pump Components and Components Location
Components 1. Water pump pulley2. Water pump 3. Water pump gasket ...

See also:

Headlight (Headlamp) escort function
If you turn the ignition switch to the ACC or OFF position with the headlights ON, the headlights (and/or parking light) remain on for about 5 minutes. However, if the driver’s door is opened and ...

Repair procedures
Starter Circuit Troubleshooting     The battery must be in good condition and fully charged. 1. Disconnect the injector connectors. 2. With the shift lever in N or P (A/T) ...

Fuel Filler Door Release Actuator Repair procedures
Inspection 1. Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts. 2. Remove the luggage side trim [LH]. (Refer to Body - "Trunk ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com