Hyundai Azera: Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body Electrical System / Electro chromic Inside Rear View Mirror / Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body Electrical System / Electro chromic Inside Rear View Mirror / Description and Operation
| Description |
The ECM (Electro Chromatic inside rear view Mirror) is for
dimming the reflecting light from a vehicle behind at night, in order
the user not to be dazzled by the light. The forward facing sensor
detects brightness of the surroundings, while the rearward looking
sensor the strength of the reflecting light so that adjusts the
reflexibility of the mirror in the range of 7~85%. But, when the reverse
gear is engaged, it stops functioning.
| 1. |
The forward facing sensor sees if the brightness of the surroundings is low enough for the mirror to operate its function. |
| 2. |
The rearward looking sensor detects glaring of the reflecting light from a vehicle behind. |
| 3. |
The ECM is darkened to the level as determined by the
rearward looking sensor. When the glaring is no longer detected, the
mirror stops functioning.
1. LED indicator
2. ON/OFF Switch
3. Rearward looking sensor
4. Forward facing sensor
|
Components and Components Location
Components(1)
Components(2)
...
Repair procedures
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front sensor to stop functioning.
3.
Sh ...
See also:
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay. IPM receives an input ...
Transmitter Specifications
Specification
ItemDescriptionPower source3VOperating temperature-20°C ~ +60°CRF ModulationFSKRF frequency433.92MHzBattery1EA (CR2032)
An inappropriately disposed battery ca ...
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com