Exhaust emissions (CO, HC, NOx) are controlled by a
combination of engine modifications and the addition of special control
components.
Modifications to the combustion chamber, intake manifold, camshaft and ignition system form the basic control system.
These items have been integrated into a highly effective
system which controls exhaust emissions while maintaining good
drivability and fuel economy.
Air/Fuel Mixture Control System [Multiport Fuel Injection (MFI) System]
The MFI system uses signals from the heated oxygen sensor to
activate and control the injector installed in the manifold for each
cylinder, thus precisely regulating the air/fuel mixture ratio and
reducing emissions.
This in turn allows the engine to produce exhaust gas of the
proper composition to permit the use of a three way catalyst. The three
way catalyst is designed to convert the three pollutants [hydrocarbons
(HC), carbon monoxide (CO), and oxides of nitrogen (NOx)] into harmless
substances. There are two operating modes in the MFI system.
| 1. |
Open Loop air/fuel ratio is controlled by information programmed into the ECM. |
| 2. |
Closed Loop air/fuel ratio is adjusted by the ECM based on information supplied by the oxygen sensor. |
Description
The catalytic converter of the gasoline engine is a three way
catalyst. It oxidizes carbon monoxide and hydrocarbons (HC), and
separates oxygen from the oxides of nitrogen (NOx). ...
See also:
Components and Components Location
Component Location
1. Panoramaroof2. Panoramaroof switch3. Panoramaroof motor & controller4. Roller blind motor & slave controller
...
Fluid Components and Components Location
Components Location
1. Injection hole(eyebolt)2. Oil level plug3. Oil drain plug
...
Push-starting
Vehicles equipped with automatic transaxle cannot be push-started. Follow the
directions in this section for jump-starting.
WARNING - Tow starting vehicle
Never tow a vehicle to start it beca ...