Hyundai Equus Manuals

Hyundai Azera: Front Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Wheel Speed Sensor Repair procedures

Removal
1.
Remove the front wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the front wheel guard .
4.
Remove the front wheel speed sensor cable mounting bolt.
5.
Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.
6.
Installation is the reverse of removal.
Front Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

See also:

Battery Sensor Description and Operation
Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a stable power su ...

Front Wheel Guard Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perfor ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com