Replacement |
1. |
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass") |
2. |
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle") |
3. |
Loosen the mounting bolt (A). |
4. |
After loosening the front door module mounting bolts, then remove the front door module (A).
|
5. |
Disconnect the connectors and front door module wiring harness (A). |
6. |
Installation is the reverse of removal.
|
Front Seat Assembly Components and Components Location
Component Location
1. Front seat assembly
...
Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...