Hyundai Azera: Front Bumper Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	After loosening the mounting bolts and clips, then remove the radiator grill side cover (A).

2.	Loosen the radiator grill upper cover mounting bolts and clips.

3.	After loosening the front bumper side mounting screw, disconnect the side.

4.	Remove the front bumper lower mounting clips.

5.	Remove the front bumper cover.

6.	Disconnect the fog lamp connector (A) and connector (B). [LH] [RH]

7.

Installation is the reverse of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Front Bumper Cover Components and Components Location

Component Location 1. Front bumper cover ...

Rear Bumper

...

See also:

Air conditioning refrigerant
Check the air conditioning lines and connections for leakage and damage. ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can re ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com