Inspection |
1. |
Remove the front door quadrant delta cover.
|
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly. Mirror Heater Inspection Puddle Lamp ECM Side Repeater Lamp Folding Mirror Memory Mirror Inspection |
Windshield Deicer Repair procedures
Inspection
1.
Remove the cowl top cover.
(Refer to Windshield Wiper/Washer - "Front Wiper Motor")
2.
Disconnect the windshield deicer connector from the wiper motor linkage.
3.
Check for ...
Description and Operation
Description
Exhaust emissions (CO, HC, NOx) are controlled by a
combination of engine modifications and the addition of special control
components.
Modifications to the combustion chamber, int ...
Power Seat Control Switch Repair procedures
Inspection
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
A : Lumb ...