Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the steering wheel.
|
3. |
Remove the cover (A) after loosening screws. |
4. |
Disconnect the upper and lower steering wheel remote control switch connector (A) in the left. |
5. |
Remove the steering wheel remote control switch assembly (A) after loosening screws. |
Installation |
1. |
Install the hands free switch to the steering wheel. |
2. |
Install the steering wheel. |
3. |
Reassemble the driver airbag module.
|
Inspection |
1. |
Check BCM input/output specification of SWRC using the GDS.
|
Rear Upper Arm Repair procedures
Removal
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts when ...
Crankshaft Position Sensor (CKPS) Specifications
Specification
ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)]Air Gap (mm)0.5 ~ 1.5
...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thro ...