Hyundai Azera: Intake Actuator Repair procedures
| Inspection |
| 1. |
Ignition "OFF". |
| 2. |
Disconnect the intake actuator connector. |
| 3. |
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7. |
| 4. |
Verify that the intake actuator operates to the fresh position when connecting in the reverse.
|
| 5. |
Check the voltage between terminals 5 and 6.
Specification
|
| 6. |
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation. |
| 7. |
If the problem is corrected, replace the intake actuator. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad.
|
| 3. |
Disconnect the Intake actuator connector (A). |
| 4. |
Loosen the mounting screw and then remove the intake actuator (B).
|
| 5. |
Installation is the reverse order of removal. |
Intake Actuator Description and Operation
ControllerRepair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left.
2.
Adjust the hood height by turning the hood overslam bumpers (C).
...
Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [ELG-A]
Pin No.DescriptionConnected to1-?2-?3-?4Immobilizer Lamp control outputImmobilizer Lamp [Without Button Engine Sta ...
Rear curtain (if equipped)
To fold the rear curtain, press the button. To unfold the rear curtain, press
the button again.
CAUTION
Do not pull or fold the rear curtain by hand. It could cause motor failure.
The rear ...