Hyundai Equus Manuals

Hyundai Azera: Cruise control system - Driving your vehicle - Hyundai Azera 2011-2024 Owners ManualHyundai Azera: Cruise control system

➀ Cruise indicator


➀ Cruise indicator
➁ SET indicator

The cruise control system allows you to program the vehicle to maintain a constant speed without depressing the accelerator pedal.

This system is designed to function above approximately 25 mph.

✽ NOTICE

WARNING - Misuse of cruise control Do not use cruise control if the traffic situation does not allow you to drive safely at a constant speed and with sufficient distance to the vehicle in front.

To set cruise control speed:

1. Push the CRUISE button on the steering wheel to turn the system on.The CRUISE


1. Push the CRUISE button on the steering wheel to turn the system on.The CRUISE indicator light in the instrument cluster will illuminate.
2. Accelerate to the desired speed, which must be more than 25 mph.

3. Push the SET- switch, and release it at the desired speed. The SET indicator


3. Push the SET- switch, and release it at the desired speed. The SET indicator light in the instrument cluster will illuminate. Release the accelerator pedal. The desired speed will automatically be maintained.

On a steep grade, the vehicle may slow down or speed up slightly while going uphill or downhill.

To increase cruise control set speed:

Follow either of these procedures:


Follow either of these procedures:

To decrease cruise control set speed:

Follow either of these procedures:


Follow either of these procedures:

To temporarily accelerate with the cruise control on:

If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with cruise control operation or change the set speed. To return to the set speed, take your foot off the accelerator pedal.

If you press the SET- switch at increased speed, the cruising speed will be set again.

To cancel cruise control, do one of the following:


Each of these actions will cancel cruise control operation (the SET indicator light in the instrument cluster will go off), but it will not turn the system off. If you wish to resume cruise control operation, push the RES+ switch located on your steering wheel.You will return to your previously preset speed.

To resume cruising speed at more than approximately 25 mph:

If any method other than the CRUISE switch was used to cancel cruising speed


If any method other than the CRUISE switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is pushed.

It will not resume, however, if the vehicle speed has dropped below approximately 25 mph.

To turn cruise control off, do one of the following:


Good braking practices
WARNING Whenever leaving the vehicle or parking, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. Vehicles not fully eng ...

Active ECO system
...

See also:

Vehicle data collection and event data recorders
This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road o ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Specifications
Specifications Direct control VFS[35R/C] ? Control type : Normal low type Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81(5.1~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Internal resi ...

Knock Sensor (KS) Repair procedures
Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the intake man ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com