On-vehicle Inspection |
Spark Test |
1. |
Remove the ignition coils.
(Refer to Ignition System - "Ignition Coil") |
2. |
Using a spark plug socket, remove the spark plug. |
3. |
Install the spark plug to the ignition coil. |
4. |
Ground the spark plug to the engine. |
5. |
Check if spark occurs while engine is being cranked.
|
6. |
Inspect all the spark plugs. |
7. |
Using a spark plug socket, install the spark plug. |
8. |
Install the ignition coil. |
9. |
Reconnect the ignition coil connector. |
Transaxle Oil Temperature Sensor Specifications
Specifications
? Type: Negative Thermal Coefficient(NTC) Type
Temp.[(°C)°F]Resistance (k?)(-40)-4048.1(-20)-4.015.6(0)32.05.88(20)68.02.51(40)104.01.11(60)140.00.61(80)176.00.32(100)212.00.18(12 ...
Output Speed Sensor Specifications
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.8~1.25) 0.032~0.049Output voltageHigh1.18~1.68Low0.59~0.84
...
Front Strut Assembly Repair procedures
Replacement
1.
Remove the front wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts ...