Hyundai Azera: Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Emission Control System / Exhaust Emission Control System / Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Emission Control System / Exhaust Emission Control System / Description and Operation
| Description |
Exhaust emissions (CO, HC, NOx) are controlled by a
combination of engine modifications and the addition of special control
components.
Modifications to the combustion chamber, intake manifold, camshaft and ignition system form the basic control system.
These items have been integrated into a highly effective
system which controls exhaust emissions while maintaining good
drivability and fuel economy.
Air/Fuel Mixture Control System [Multiport Fuel Injection (MFI) System]
The MFI system uses signals from the heated oxygen sensor to
activate and control the injector installed in the manifold for each
cylinder, thus precisely regulating the air/fuel mixture ratio and
reducing emissions.
This in turn allows the engine to produce exhaust gas of the
proper composition to permit the use of a three way catalyst. The three
way catalyst is designed to convert the three pollutants [hydrocarbons
(HC), carbon monoxide (CO), and oxides of nitrogen (NOx)] into harmless
substances. There are two operating modes in the MFI system.
| 1. |
Open Loop air/fuel ratio is controlled by information programmed into the ECM. |
| 2. |
Closed Loop air/fuel ratio is adjusted by the ECM based on information supplied by the oxygen sensor. |
Catalytic Converter Description and Operation
Description
The catalytic converter of the gasoline engine is a three way
catalyst. It oxidizes carbon monoxide and hydrocarbons (HC), and
separates oxygen from the oxides of nitrogen (NOx). ...
See also:
Brake Line Repair procedures
Removal
1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
...
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).
3.
Remove the rear door latch assembly (A).
4.
I ...
Dynamic Damper Components and Components Location
Components
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circlip
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com