Hyundai Azera: Barometric Pressure Sensor (BPS) Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Repair procedures
| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage of the BPS at idle and IG ON.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the barometric pressure sensor connector (A). |
| 3. |
Remove the installation bolt (B), and then remove the sensor from the air cleaner assembly.
|
| Installation |
|
|
| 1. |
Installation is reverse of removal.
|
Barometric Pressure Sensor (BPS) Schematic Diagrams
Circuit Diagram
...
Intake Air Temperature Sensor (IATS) Description and Operation
Description
Intake Air Temperature Sensor (IATS) is included inside Barometric Pressure Sensor (BPS) and detects the intake air temperature.
To calculate precise air quantity, correction of the ai ...
See also:
Battery Repair procedures
Removal and Installation
1.
Remove the air duct (B).
2.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
3.
D ...
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
engi ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAWR. ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com