Hyundai Azera: Repair procedures
| Adjustment |
| Transaxle Control Module(TCM) Learning |
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement |
| • |
TCM replacement |
| • |
TCM upgrading
|
| TCM learning procedure |
| 1. |
ATF temperature: 40~100°C (104~212°F) |
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st,
2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified TPS value (15~25%). |
Description and Operation
Description
Automatic transaxle system relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to con ...
Schematic Diagrams
Circuit Diagram
...
See also:
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Smart key antenna Specifications
Specification
Antenna
ItemsSpecificationRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-30°C ~ 75°C (-22°F ~ 167°F)Frequency134.2kHzNumbersInterior(3EA), Door(2EA), Bumper(1EA) ...
Parking Assist Sensor Repair procedures
Removal
[Front parking assist sensor]
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Pull out the front sensor (A) from the sensor holder by opening the sensor holder ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com