Hyundai Azera: Wheel Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures
| Lug nut tightening sequence |
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
Run out inspection
| 1. |
Jack up the vehicle. |
| 2. |
Measure the wheel Run-out by using a dial indicator as illustration below.
| ||||||||||||
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Tire Repair procedures
•
Using tires and wheel other than the recommended sizes could
cause unusual handling characteristics and poor vehicle control,
resulting in a serious accident.
Tire ...
Alignment Repair procedures
Front Wheel Alignment
When using a commercially available computerized wheel
alignment equipment to inspect the front wheel alignment, always
position the vehicle on a lev ...
See also:
Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components
1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring
...
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram
...
Rear Seat Assembly Components and Components Location
Component Location
1. Rear seat cushion assembly2. Rear seat back assembly
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com