Hyundai Equus Manuals

Hyundai Azera: Curtain Airbag (CAB) Module Repair procedures - Airbag Module - Restraint - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Curtain Airbag (CAB) Module Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
3.
Disconnect the curtain airbag harness connector (A).

4.
After loosening the mounting bolts remove the curtain airbag (A).

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque :
10.8 ~ 14.7 N.m (1.1 ~ 1.5 kgf.m, 8.0 ~ 10.8 lb-ft)
   
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Components and Components Location
Components ...

Knee Airbag (KAB) Module Description and Operation
Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. ...

See also:

Active ECO system
...

Rear Console Cover Components and Components Location
Component Location 1. Rear console cover ...

Description and Operation
Refrigeration Cycle Air Outlet and Air Flow The mode selection switch controls the direction of the air flow through the ventilation System Air FlowSymbolOutletDescriptionVentB,C,D,E,FAir f ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com