Hyundai Azera: Knee Airbag (KAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
After loosening the mounting nuts and then remove the knee airbag (A).
|
| 4. |
Disconnect the knee airbag harness connector (A).
|
| Installation |
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Connect the knee airbag connector. |
| 4. |
Tighten the knee airbag mounting nuts.
|
| 5. |
Install the crash pad lower panel.
|
| 6. |
Install the crash pad side cover.
|
| 7. |
Reconnect the battery negative cable. |
| 8. |
After installing the knee airbag, confirm proper system operation:
|
Knee Airbag (KAB) Module Components and Components Location
Airbag Module Disposal Description and OperationCrash Pad Side Cover Components and Components Location
Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Fuel Pressure Control Valve (FPCV) Troubleshooting
Signal Waveform
...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as poss ...