Hyundai Azera: Gate operator & Canadian programming
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Owners Manual / Features of your vehicle / Mirrors / Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLink® Wireless Control System button (note steps 2 through 4 in the Standard Programming portion of this document) while you press and re-press ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training.
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
, ), HomeLink® Channel 1 and Channel
3, until the indicator light begins ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, hom ...
See also:
High mounted stop light replacement
If the light bulb does not operate, have the vehicle be checked by an authorized
HYUNDAI dealer.
A skilled technician should check or repair the high mounted stop light. Otherwise,
it may affect ...
TPMS Receiver Schematic Diagrams
Circuit Diagram
Connector pin number
Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground
...
Multimedia Jack Repair procedures
Removal
1.
Remove the center fascia tray.
(Refer to Body - "Floor Console Assembly")
2.
Disconnect the connectors (A) from center fascia tray.
3.
Remove the multimedia jack (B) from the c ...
Categories
Hyundai Azera Manuals
