Hyundai Azera: Ignition Coil Repair procedures
| Removal and Installation |
| [LH] |
| 1. |
Disconnect the battery nagative terminal. |
| 2. |
Remove the engine cover. |
| 3. |
Disconnect the LH ignition coil connectors (A) and then remove the LH ignition coils.
|
| 4. |
Installation is reverse order of removal. |
| [RH] |
| 1. |
Disconnect the battery nagative terminal. |
| 2. |
Remove the surge tank.
|
| 3. |
Disconnect the RH ignition coil connectors (A) and then remove the RH ignition coils.
|
| 4. |
Installation is reverse order of removal. |
| Inspection |
| 1. |
Measure the primary coil resistance between terminals (+) and (-).
|
Ignition Coil Components and Components Location
Spark Plug Components and Components LocationRepair procedures
Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration, and replace them if necessary.
1.
Remove the front door trim.
(Refer to Front Door - "Front Door T ...
Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
...
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn ...