Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use.
Whenever the ENGINE START/STOP button is changed to the ON position, the immobilizer system checks and verifies if the key is valid or not. If the key is valid, the engine will start. If the key is invalid, the engine will not start.
To deactivate the immobilizer system
Change the ENGINE START/STOP button to the ON position.
To activate the immobilizer system
Change the ENGINE START/STOP button to the OFF position.The immobilizer system activates automatically. Without a valid smart key for your vehicle, the engine will not start.
✽ NOTICE
Your immobilizer password is a customer unique password and should be kept confidential. Do not leave this number anywhere in your vehicle.
CAUTION
Keep each key separate in order to avoid a starting malfunction.
CAUTION
Do not put metal accessories near the smart key. The engine may not start because the metal accessories may interrupt the transponder signal from transmitting normally.
If you need additional keys or lose your keys, consult an authorized HYUNDAI dealer.
CAUTION - Immobilizer damage
Do not expose your immobilizer system to moisture, static electricity and rough handling. This may damage your immobilizer.
CAUTION - Immobilizer alterations
Do not change, alter or adjust the immobilizer system because it could cause the immobilizer system to malfunction.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Rear Disc Brake Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Loosen the bolt & nut and then disconnect the shock absorbe ...
Camshaft Position Sensor (CMPS) Troubleshooting
Wave Form
...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thro ...