Hyundai Equus Manuals

Hyundai Azera: In-car sensor Repair procedures - Air Conditioning System - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2025 Service ManualHyundai Azera: In-car sensor Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / In-car sensor Repair procedures

Inspection
1.
Ignition "ON"
2.
Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals.

1. Incar Motor(-)
2. Sensor GND
3. -
4. Incar Sensor (+)
5. -
6. IGN2 (Incar Motor (+))

Temperature [°C(°F)]
Resistance between terminals 2 and 4 (k?)
60(140)
7.463 ± 2.6%
50(122)
10.810 ± 2.2%
35(95)
19.59 ± 1.6%
25(77)
30.00 ± 1.2%
15(59)
47.130 ± 1.7%
0(32)
97.710 ± 2.4%
-15(5)
216.1 ± 3.2%
-30(-22)
509.6 ± 4.1%

   
In car sensor is negative type thermistor that resistance will rise with lower temperature, and reduce with higher temperature.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lower crash pad.
3.
Disconnect the connector of in-car sensor.
Loosen the mounting 2 screws and then remove the in-car sensor (B).

4.
installation is the reverse order of removal.
In-car sensor Description and Operation
Description 1. In-car air temperature sensor is located at the lower crash pad. 2. The sensor contains a thermistor which measures the temperature of the cabin. The signal, determined by the ...

Photo Sensor Description and Operation
Description 1. The photo sensor is located at the center of defrost nozzle. 2. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its lig ...

See also:

Electronic power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require ...

GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAWR. ...

Front Bumper Cover Repair procedures
Replacement     • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and pan ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com