Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.

No.
| Description
| No.
| Description
|
1
| -
| 4
| Room door
|
2
| GND (-)
| 5
| Mood (+)
|
3
| Door (-)
| 6
| Battery (+)
|


1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the overhead console lamp assembly with removal. |
3. |
Remove the overhead console lamp after disconnecting the panoramaroof switch connector and lamp connector (A). 

|
4. |
If necessary to replace the bulb, replace the bulb (B). |
1. |
Install the overhead console lamp after connecting the panoramaroof switch connector and lamp connector. |
2. |
Install the lens after tightening 2 screws. |
Removal
Room lamp(General type)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the room lamp assembly (A) with (-) screwdriver.
3.
Remove the LED bulb (A).
Room lamp(Panoram ...
Removal
Mood lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
3.
Remove the connector(A) and door LED mood l ...
See also:
(if equipped)
The system has been equipped with a rear view camera for user safety by
allowing a wider rear range of vision.
The rear view camera will automatically operate when the ENGINE START/STOP
butto ...
Main Muffler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
(Refer to Engine Electrical System - "Battery")
2.
Remove the main muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m ( ...
Before starting
Close and lock all doors.
Position the seat so that all controls are easily reached.
Adjust the inside and outside rearview mirrors.
Be sure that all lights work.
Check all gauges.
Check ...