Inspection |
1. |
Disconnect the connectors for each motor.
A : Front height motor
B : Slide motor
C : Rear height motor
D : Recline motor
E : Lumbar support motor
F : Cushion extension motor |
2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
3. |
Reverse the connections and check that the motor turns in reverse. |
4. |
If there is an abnormality, replace the motors. |
Line Pressure Control Solenoid Valve Specifications
Specifications
Direct control VFS[LINE Pressure]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81(5.1~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Inter ...
To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot (HIGH) position.
3. Press the defroster button ().
4. The air conditioning will be turned o ...
Ignition Coil Repair procedures
Removal and Installation
[LH]
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH ignition coil connectors (A) and then remove the LH ignition ...