Hyundai Azera: Repair procedures
| Adjustment |
| Transaxle Control Module(TCM) Learning |
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement |
| • |
TCM replacement |
| • |
TCM upgrading
|
| TCM learning procedure |
| 1. |
ATF temperature: 40~100°C (104~212°F) |
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st,
2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified TPS value (15~25%). |
Description and Operation
Description
Automatic transaxle system relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to con ...
Schematic Diagrams
Circuit Diagram
...
See also:
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2 ...
Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the speci ...
Additional safety precautions
All occupants should sit upright, fully back in their seats with their seat
belts on and their feet on the floor.
Passengers should not move out of or change seats while the vehicle is moving.
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com