Hyundai Azera: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
| Specifications |
Direct control VFS[UD/B]
? Control type : Normal low type
| Control Pressure [kpa (kgf/cm?, psi)] | 500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42) |
| Current value(mA) | 50~850 |
| Internal resistance(?) | 5.1 |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and Operation
Description
Underdrive brake control solenoid valve(UD/B) is attached to
the valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the underdrive brake. ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Circuit Diagram
...
See also:
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1.
Perform "ECM Neutr ...
Mode Control Actuator Repair procedures
Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the term ...
Categories
Hyundai Azera Manuals
2011-2026 Copyright www.hgmanual.com