Inspection |
1. |
The windshield deicer switch inputs can be checked using the GDS. |
2. |
To check the input value of windshield deicer switch, select option "IPM". |
3. |
Select option "Current Data". |
4. |
To check the input value of windshield deicer switch in force mode, select option. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the center fascia panel.
|
3. |
Remove the heater control unit (A) after removing screws. |
Installation |
1. |
Install the heater control unit. |
2. |
Install the center fascia panel. |
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Hands Free Mic Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the handsfree mic (A) after disconnect the connector f ...
Thermostat Components and Components Location
Components
1. Water temperature control assembly2. Thermostat3. Water inlet fitting
...