Hyundai Equus Manuals

Hyundai Azera: Turn Signal Lamp Repair procedures - Lighting System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Turn Signal Lamp Repair procedures

Removal
Door mirror turn signal lamp
1.
Disconnect the negative (-) battey terminal.
2.
Remove the mirror (A).

3.
Remove the outside mirror cover (A).

4.
Remove the lower cover (A) of outside rear view mirror.

5.
Detach the lower part from the upper part after loosening screws (4EA).

6.
Remove the outside rear view mirror actuator (A) and 2 screws (B). Disconnect the connector and remove the door mirror turn signal lamp (C).

7.
The installation is the reverse of removal.
Puddle lamp
1.
Remove the puddle lamp(A) under the outside rear mirror.

Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A). ...

Trunk Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp (B) when prying the clip (A) with a flat-up screwdriver. 3. Remove the luggage room lamp bulb in ca ...

See also:

SS-B Solenoid Valve(ON/OFF) Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ? Control type : Normal low type Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11 ...

Vanity mirror lamp
Opening the lid of the vanity mirror will automatically turn on the mirror light. CAUTION To prevent unnecessary charging system drain, close the vanity mirror cover after using the mirror. ...

Barometric Pressure Sensor (BPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com