Hyundai Azera: Water Jacket Seperator Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Repair procedures
| Removal |
| 1. |
Remove the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head") |
| 2. |
Remove the water jacket seperator (A).
|
| Installation |
| 1. |
Install the #1, #2 cylinder bore water jacket seperator (A).
|
| 2. |
Install the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head") |
Water Jacket Seperator Components and Components Location
Components
1. Water jacket separator
...
Drive Plate Components and Components Location
Components
1. Drive plate2. Adapter plate
...
See also:
Hood Seal Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the hood seal weatherstrip (A).
•
Be careful not to scratch the hood seal weatherstrip.
2.
Installation is the rev ...
Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the steering wheel.
(Refer to Steering ...
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com